Brief description
This data release consists of flux tower measurements of the exchange of energy and mass between the surface and the atmospheric boundary-layer in semi-arid eucalypt woodland using eddy covariance techniques. It been processed using PyFluxPro (v3.3.0) as described in Isaac et al. (2017), https://doi.org/10.5194/bg-14-2903-2017. PyFluxPro takes data recorded at the flux tower and process this data to a final, gap-filled product with Net Ecosystem Exchange (NEE) partitioned into Gross Primary Productivity (GPP) and Ecosystem Respiration (ER). For more information about the processing levels, see https://github.com/OzFlux/PyFluxPro/wiki.This is a topographically flat area, primarily comprised of the following soil types: sandy loams, scattered clays, red brown earths, transitional red brown earth, sands over clay and deep sands. Stream valleys and layered soil and sedimentary materials are found across the landscape.
The flux station tower extends to 20m, however flux measurements are recorded from slightly lower than this. Mean annual precipitation from a nearby Bureau of Meteorology site measured 465 mm. Maximum temperatures ranged from 37.4°C (in January) to 16.6°C (in July), while minimum temperatures ranged from 29.0°C (in January) to 11.8°C (in July). Maximum temperatures varied on a seasonal basis by approximately 20.8°C and minimum temperatures by 17.2°C.
The site is within a wider research area (60 x 60 km) that supports a network of flux stations, which have been in operation since late 2001 onwards.
Lineage
All flux raw data is subject to the quality control process OzFlux QA/QC to generate data from L1 to L6. Levels 3 to 6 are available for re-use. Datasets contain Quality Controls flags which will indicate when data quality is poor and has been filled from alternative sources. For more details, refer to Isaac et al (2017) in the Publications section, https://doi.org/10.5194/bg-14-2903-2017 .
Notes
CreditWe at TERN acknowledge the Traditional Owners and Custodians throughout Australia, New Zealand and all nations. We honour their profound connections to land, water, biodiversity and culture and pay our respects to their Elders past, present and emerging.
The site was established in April 2012 as part of a project run with the Japanese Aerospace Exploration Agency (JAXA), and is managed by The University of Western Australia. Primary investigators and contributors are named in the citation.
The flux station is part of the Australian OzFlux Network and contributes to the international FLUXNET Network.
To provide additional validation data for GCOM-W1 soil moisture products, which are components of a land surface data assimilation system. These data systems are important for land surface models, which rely on atmosphere-surface observations. Information provided by an existing network of soil moisture monitoring systems will also be used to validate the GCOM-W1 soil moisture product.
For validation of the Advanced Microwave Scanning Radiometer-2 (AMSR2) soil moisture product and resulting soil moisture and flux estimates.
For crop modelling, runoff, flood forecasting, Land Surface Model forcing data (i.e. input of AMSR2 soil moisture into the Joint UK Land Environment Simulator (JULES) model).
Data Quality Assessment Scope
local :
dataset
If the data quality is poor, the data is filled from alternative sources. Filled data can be identified by the Quality Controls flags in the dataset. Quality control checks include (i) range checks for plausible limits, (ii) spike detection, (iii) dependency on other variables and (iv) manual rejection of date ranges. Specific checks applied to the sonic and IRGA data include rejection of points based on the sonic and IRGA diagnostic values and on either automatic gain control (AGC) or CO2 and H2O signal strength, depending upon the configuration of the IRGA. For more details, refer to Isaac et al (2017) in the Publications section, https://doi.org/10.5194/bg-14-2903-2017.
For further information about the software (PyFluxPro) used to process and quality control the flux data, see https://github.com/OzFlux/PyFluxPro/wiki .
Created: 2021-08-06
Issued: 2021-09-20
Modified: 2024-05-07
Data time period: 2013-01-01 to 2021-07-24
text: The site is located 37km South West of Narrandera, in the Yanco region of New South Wales.
User Contributed Tags
Login to tag this record with meaningful keywords to make it easier to discover
- URI : geonetwork.tern.org.au/geonetwork/srv/eng/catalog.search#/metadata/07338ac7-11c0-4a85-a86e-7cbb2755300c
- global : 07338ac7-11c0-4a85-a86e-7cbb2755300c